Filter
Top Products
5. Remove the new control board from the electrostatic packaging. Carefully, bend the front of the board up
until the tabs between the circuit boards separate. The boards will remain connected by trace wires. Be
careful not to damage components on the topside of the board.
6. Position the tabs from the front of the board under the edge of the main board until it is bent to about a
40° angle.
7. Reconnect the wiring connectors to the new board.
8. Install the new board under plastic retaining clips on the control box.
9. Replace the control panel.
10. Plug in refrigerator or reconnect power.
8
Front
Front board tab
under main board
Tab