Filter
Top Products
7
Check operation
control panel
location
light
switch
blower
switch
blower speed
switch
19 . Check the operation of the
range hood:
ࠜ Move light switch to “1” position.
The light should turn on.
ࠜ Move blower switch to “1”
position. The blower should
operate.
ࠜ Move the blower speed switch to
the far left; blower speed should
be LOW. Move blower speed to
right; blower speed should
gradually increase until you reach
HIGH speed at far right.
ࠜ Move blower and light switches to
“0” position to turn blower and
light off.
If range hood does not operate:
ࠜ Check that the circuit breaker is
not tripped or the house fuse
blown.
ࠜ Disconnect power supply. Check
that wiring is correct.
18 . The canopy hood controls
are located in a grey panel on
underside of the canopy. To open the
panel, press on the front edge of
panel and release. The control panel
will drop down.
16 . Place filters in canopy open-
ings so rear edge is over flange. Press
filters up into position.
17. Turn power on.
To g et the most efficient
use from your new range
hood, read the “Use and
Care Information” section.
Keep your KitchenAid
Installation Instructions and
Use and Care Guide close
to range hood for easy
reference.