Filter
Top Products
7
4. Place rubber seal on hood venting area; make sure the openings on rubber seal are aligned
with openings in vent area. Shown in Figure 7. Align plastic damper on rubber seal and
attach to hood using eight 4x20 mm screws (provided). Refer to Figure 8
Figure 7 Figure 8
5. If necessary, remove the two rubber stands at the back of the
hood. For a more secure installation, KOBE recommends
not removing the rubber stands.
6. Using references in Table 1 and Measurement & Diagrams on
page15, mark the leveling line for hood-mounting bracket.
Secure hood-mounting bracket to wall with screws (not
provided). Refer to Figure 9.
Figure 9
7. Align hood to the hood-mounting bracket on the wall and hook hood into place as shown in
Figure 10 & 11. CAUTION: MAKE SURE THE HOOD IS SECURE BEFORE RELEASING.
Figure 10 Figure 11
8. For safety purposes, install the safety bracket (provided) with one
screw (not provided) to the wall as shown in Figure 12.
Figure 12