KoldFront KIM450S Ice Maker User Manual


 
KoldFront Built-in Ice Maker 10
Normal Sounds
Your new icemaker may make sounds that are not familiar to you. Most of
the new sounds are normal. Hard surfaces like the floor, walls can make
the sounds seem louder than they actually are. The following describes
the kinds of sounds that might be new to you and what may be making
them.
Ratting noises may come from the flow of the refrigerant or the
water line, Items stored on top of the icemaker can also make
noises.
The high efficiency compressor may make a pulsating or high-
pitched sound.
Water running from the evaporator to the water bin may make a
splashing sound.
As each cycle ends, you may hear a gurgling sound due to the
refrigerant flowing in your icemaker.
You may hear air being forced over the condenser by the
condenser fan.
During the harvest cycle, you may hear the of ice cubes falling into
the ice storing bin.
Preparing the Icemaker for Long Storage
If the ice maker will not be used for a long time, or is to be moved to
another place, it will be necessary to drain the system of water.
1. Shut off the water supply at the main water source.
2. Disconnect the water supply line from the water inlet.
3. Shut off the electric supply at the main electrical power source.
4. Take out the ice storage bin to remove ice and water. Dry it.
6. Pull off the drainage tube of the water trough to drain off all water.
7. Leave the door open to allow for circulation and to prevent mold and
mildew.
8. Leave the water supply line and power cord disconnected until ready to
reuse.
IMPORTANT:
Do not touch the power plug when your hands are wet.
Never unplug the unit by pulling on the plug.