Filter
Top Products
KoldFront Built-in Ice Maker 6
Leveling the Ice Maker
It is important for the icemaker to be leveled in order to work
properly. It can be raised or lowered by rotating the plastic sheaths
around each of the four feet on the bottom of the machine .If you
find that the surface is not level, rotate the feet until the ice maker
becomes level .You may need to make several adjustments to
level it. We recommend using a carpenter’s level to check the
machine.
1. Place a carpenter’s level on top of the product to see if the ice
maker is level from front to back and side to side .
2. Adjust the height of the feet as follows:
Turn the leveling feet to the right to lower that side of the ice maker
Turn the leveling feet to the left to raise that side of the ice maker .
IMPORTANT: Once you are ready to install it in a cabinet or directly
on the floor, you must adjust the feet to level the ice maker. If the
floor is level, just revolve the two front feet to touch the floor.
Reversing the Door Swing
Tools needed: flathead screwdriver, Phillips screwdriver
IMPORTANT: Before you begin, unplug the ice maker or
disconnect power.
To remove door from hinges:
1. Using a Phillips screwdriver, remove the screws and take off top
hinge. Keep the parts together and set them aside.
3. Lift door off bottom hinge and turn it upside down so that the
handle is on the right. Set door aside.
To replace door on hinges:
1. Using a flathead screwdriver, remove the plug buttons from the
screw holes opposite the door hinges, top and bottom. Set aside.
2. Remove the bottom hinge, place on the opposite side at the
bottom of the door.
3. Position the door on the bottom hinge.
4. Align the door on the bottom hinge and replace the top hinge.
5. Push the plug buttons into the original screw holes.
Door Hinge
Cabinet
Door
Door
Bottom hinge