Kompernass KH 1112 Coffeemaker User Manual


 
- 4 -
Operation
Before the First Use
ƽ
IMPORTANT!
Never fill more than a total of 1.3 litres of tap
water into the water container. The minimum
quantity in the water container and the minimum
quantity of brewed coffee in the glass coffee-pot
is 250 ml. Otherwise the coffee maker could be
damaged.
Disconnect the coffee maker from the power sup-
ply immediately after use. The coffee maker is
only fully currentless when you pull the plug out
of the wall socket.
Only pour tap water into the water container.
Otherwise you may damage the coffee maker.
open the glass coffee-pot
u
and the water
contaier.
Carefully rinse the water container and the glass
coffee-pot with tap water.
Fill the glass coffee-pot with max. 1.3 litres of tap
water.
Pour all the tap water into the water container
(fig.C).
Place the empty glass coffee-pot onto the
hotplate.
Switch the coffee maker on and wait until the
coffee-making procedure has finished.
Empty the glass coffee-pot.
Switch the coffee maker off by pressing the
mains switch again
t
, until the power on light
goes out.
Then you can use the coffee maker to make fresh
coffee.
Fill in ground coffee
Swing out the filter holder
q
(fig. D).
Place an opened size 4 paper filter into the filter
holder. (First fold the bottom filter paper edge
over)
Fill the ground coffee into the paper filter.
Allow approx. one level coffee measure per
small cup of ground coffee. For large cups, al-
low approx. one heaped coffee measure per
cup. If the coffee is too strong, you can reduce
the amount of ground coffee per cup to taste.
Close the filter holder.
Fill water
Open the water container lid
i
.
Fill the glass coffee-pot
u
with tap water.
Pour the tap water for the amount of coffee
required into the water container (fig.C).
Close the water container lid
i
.
Switching on and off
If you wish to switch on the coffee maker, press
the power switch
t
, until the red pilot lamp
lights up.
If you wish to switch off the coffee maker, press
the power switch until the pilot lamp goes out.
Then pull the power plug out of the wallsocket.
Wind up the cord
Push the cord into the cord compatment on the
back of the machine (fig.B).
If necessary, push the metal contact
of the plug into the holes above the cord com-
partment.
IB_KH1112_E3340_LB4 22.02.2008 9:38 Uhr Seite 4