Filter
Top Products
Install the Kramer RK-1UTB/T Under the Table Enclosure
5
5 Install the Kramer RK-1UTB/T Under the Table Enclosure
To install the RK-1UTB/T you have to:
• Mount the Kramer devices on the RK-1UTB/T (see section
5.1)
• Attach the RK-1UTB/T under the table (see section
5.2)
• Install the cables (see section
5.3)
This section also describes how to:
• Mount units that do not have underside screw holes (see section
5.4)
• Connect a blank panel (see section
5.5)
5.1 Mount the Kramer devices on the RK-1UTB/T
The example illustrated in
Figure 1 shows the TP-120OD Kramer TOOL with
the Kramer 1/4U TP-953.
5.1.1 Installing a Kramer TOOL
To mount a Kramer TOOL do the following:
1. Remove the two TOOL M3x6 side screws
1
2. Attach the “L” shaped bracket to the TOOL and screw in the appropriate
hole to the right side panel
.
2
Figure 3 of the TOOL (see ).
Figure 3: Attaching the “L” Shaped Bracket
1 In some TOOL models, two M3x6 screws are attached to the sides of the Tool and can be used to fasten the brackets.
Otherwise, ignore this step, use the side screws supplied with the kit, and continue to step 2
2 With front panel facing you