Filter
Top Products
The “Stop’n Serve” feature~is~l&UPS’
answer to the impatient coffee
drinker’s clamor for “a quick cup of
coffee!” This device automatically
stops the flow of brewed coffee
through the filter cone if the glass
carafe is removed from the warming
plate during the brewing cycle. You
have about 20 seconds between the
removal of the carafe and its being
reinserted to allow the serving of one
or two cups of coffee.
The “Stop’n Serve” device closes off
the filter cone so effectively that there
is virtually no coffee-drip onto the
warming plate (one drop, at most!).
Once the carafe is replaced, the
brewing cycle and the flow of the
coffee into the carafe are resumed.
A
Caution
If the coffee does drip onto the
warming plate after removal of the
carafe, it is usually an indication that
the small seal in the filter holder is
missing or defective. It is also possible
that too much ground coffee has been
placed into the paper filter. This causes
the water that jets into the filter cone to
overflow between the paper filter and
the sides of the filter cone.
This overflow carries coffee grounds
with it that interfere with the snap-shot
action of the filter holder, thus allowing
brewed coffee to continue to drip
through.
If this blockage and subsequent
dripping do occur, replace the glass
carafe immediately and allow the full
brewing cycle to run its course. Do not
swing out the swivel filter until the
brewing cycle is completed.
This feature enables you to enjoy
freshly brewed coffee at any pre-
selected time within a 24-hour period.
To use this feature, you must first set
the digital clock (see Setting the Time):
1. Press the “prog”
button=
(01.
The
display will change from the current
clock setting to “Wake-Up” setting.
The
R
symbol will appear in the
display and the display will not flash.
2. Immediately select the time in which
you would like the brewing process
to commence (see diagram below).
1
3
1
Display
I
Set the
hour
Press the
progr.
“prog” button
!&
mm.
Set the
minutes
onioff
3. Once you have set the “Wake-Up“
time, either press the “prog” key or
wait approximately 4 seconds. The
current clock time will reappear and
the display colon will flash.
11