Krups 880-42 Coffeemaker User Manual


 
15
Description
a Lid for removable tank
b Removable water tank
c Steam tap
d Steam nozzle
e Cappuccino accessory
f Filter holder
g Cup rest grid
h Drip tray
i Pump switch
j Temperature indicator light (yellow)
k « On » indicator light
l On/Off switch
m Cord storage
n Filters for one or two cups
o Measuring spoon
Safety recommendations
Before using your espresso for the first time,
please read these instructions carefully.
Only use an earthed plug to connect the
appliance. Check that the voltage indicated
on the information plate on the appliance
does in fact match that of your electrical
wiring system.
Wiring instructions for U.K and Ireland only :
APPLIANCES WITH FITTED PLUG
Important : For your convenience this
appliance is supplied complete with a plug
incorporating a 13 amp fuse.
In the event of replacing a fuse in the plug
supplied, a 13 amp fuse approved by ASTA to
BS1362 must be used.
If the socket outlets are not of the 13A BS
1363 type, and therefore do not accept the
plug connected to this appliance, cut off the
plug.
When cut off, this plug is a shock hazard if
inserted into a socket outlet and must therefore
be disposed of safely.
If the fuse cover is detachable, never use the
plug with the cover omitted. Replacement
covers can be obtained from your service agent.
Fit the appropriate plug according to the
instructions in paragraph «Fitting a plug».
With alternative plugs a 15 amp fuse must be
fitted either in the plug or adaptor or at the
main fuse box.
APPLIANCES WITHOUT FITTED PLUG
FITTING A PLUG - IMPORTANT
The wires in the mains lead are coloured in
accordance with the following code:
GREEN & YELLOW : EARTH
BLUE : NEUTRAL
BROWN : LIVE
As the colours in the mains lead of this
appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured GREEN & YELLOW
must be connected to the terminal in the plug
which is marked with the letter ‘E’ or by the
earth symbol
or coloured green or green
and yellow. The wire which is coloured BLUE
must be connected to the terminal which is
marked with the letter ‘N’ or coloured black.
The wire which is coloured BROWN must be
connected to the terminal which is marked
with the letter ‘L’ or coloured red.
This appliance is manufactured to conform to
the Low Voltage Electrical Equipment (Safety)
Regulations 1989 and is designed to comply
with BS 3456. It complies with the
requirements of the EEC Directive (89/336/
EEC).
Do not place your espresso maker on a hot
surface (electrical hotplate, for example) or
close to a flame.
Do not remove the filter holder containing
the coffee while water is running through,
as the appliance is under pressure at this
time.
Do not use the appliance when the drip tray
and the grid are not in place.
Unplug the appliance if a problem occurs
while the coffee is running through or
before cleaning it.
Do not unplug the appliance by pulling on
the cord and do not place the cord on a
sharp edge or the corner of an item of
furniture.
English
ART. 880.PM6.5 19/01/04, 16:0115