Filter
Top Products
9
• As indicated in the figures of the previous page, the machines have 2
dispensing buttons for each granulated product:
- Large cup: long dose
- Small cup: short dose
In addition, they have a rinse button for each mixer unit installed.
The name assigned to the buttons in the figure (e.g. A1-A2), indicates the
name of the controlled mixer unit, A is the first one from the left.
PRELIMINARY OPERATIONS
Before inserting the plug and switching the machine on, remove the water
tank, thoroughly rinse it and fill it with fresh water.
Replace the tank, ensuring that the level sensor is immersed in the water.
Pour in the tank only fresh drinking still water. Hot water or other liquids
can damage the machine.
Do not start the machine without water; for correct dispensing, the softener
filter located at the end of the intake tube must be immersed completely.
LOADING THE GRANULATED PRODUCT
IMPORTANT NOTICE:
The products dispensed by the machine with the appropriate mixing and
associations to the control panel are preset at the factory.
It is not possible to dispense different products from the ones for which the
machine is manufactured.
For machines equipped with more than one canister, make sure that each
product is located in the correct position.
Remove the canister, rinse it and dry it thoroughly. Pour the granulated
powder product, then fit the lid and replace the canister in its place. Verify
that the pin protruding from the base is inserted into the corresponding hole
of the machine.
YES