Leica Sp9000 Kitchen Utensil User Manual


 
22
Instruction manual V2.2 – 08/2007
3. If the plastic glass retainers are not in place, install them on the posts on
the platform and tighten the two thumb screws in each one (Figure 15).
The two glass retainers may be left in place during knife sharpen-
ing.
4. Position one hone glass on the plate holder and tighten thumbscrew (fin-
ger tight only). Be sure that the top surface of the clamp is below the top
surface of the glass (Figure 16).
7. Redressing hone glass plates
Abb. 22.1 Abb. 22.2
5. Shake Leica Hone Glass Compound thoroughly until all particles are in
suspension. If necessary, remove dispenser top and stir to mix contents.
Apply an ,S“ shaped line of compound over the surface of the plate (Fig-
ure 17). There must be sufficient compound so that the entire plate sur-
face will be covered when the second plate is inserted and redressing
begins.
USE ONLY LEICA HONE GLASS COMPOUND. DO NOT USE DRY
ABRASIVE.
ALL TRACES OF HONE GLASS COMPOUND MUST BE REMOVED
FROM GLASS PLATES BEFORE SHARPENING KNIVES.
6. Place the second plate between the two glass retainers so that it is lying
flat. It is unimportant as to which side is down first (Figure 18).