Filter
Top Products
9. Troubleshooting
9-2
Table 9.1(D) Abnormal operation of function
Error code Error indication Error contents
E03-01
High speed link
parameter error in error
status dialog box.
This error happens when
parameter is
not set well or not set at all, or it is broken, after setting
link-enable of on-line.
E03-02
High speed link
communication is not
performed.
When communication is not made well even though
is normal after setting link-enable.
E03-03
Contacts of _HSxRLNK and _HSxTRX are
not set to ‘On’ during
.
When _HSxRLNK is not set to ‘On’ even though
parameter is normal after setting link-enable.
E03-04
Contacts of _HSxTRBL, etc. are set to On
during
.
After setting link-enable and _HSxRLNK of
is set to ‘On’, when HSxLTRBL is set to ‘On’ by the
problem of PLC and communication in normal status.
Table 9.1(E) Abnormal operation of communication command service function
Error code Error indication Error contents
E04-01
When service is performed by Fnet, ERR
contact of communication command is set
to ‘On’ and the value of status is not ‘0’.
ERR of communication command is set to ‘On’, or
NDR/ERR of communication command doesn’t become
‘1’.
E04-02
When service is performed by Mnet, ERR
contact of communication command is set
to ‘On’ and the value of status is not ‘0’.
ERR of communication command is set to ‘On’, or
NDR/ERR of communication command doesn’t become
‘1’.
Table 9.1(F) Abnormal operation of GMWIN communication service function
Error code Error indication Error contents
E05-01
Message of [No response] occurs during
remote connection request.
RS-232C cable is not connected between GMWIN and
PLC or the power of PLC is off.
E05-02
When other error message occurred during
remote connection request.
Service is not performed well because request is not
relevant.