Filter
Top Products
9
Malfunctions
You may be able to rectify the following faults by checking
the possible causes yourself:
• Appliance does not function:
– Is the appliance switched on?
– Is the plug correctly fitted in the mains socket?
– Is the socket fuse intact?
• Loud running noise:
– Is the appliance set up firmly on the floor?
– Does the appliance cause nearby items of furniture or objects to
vibrate? Ensure that the appliance is stable and that all parts at
the back can vibrate freely.Please note that noises caused by the
refrigerant circuit cannot be avoided.
• The temperature is not low enough:
– Is the temperature setting correct (see „Setting the temperature“)?
– Does the separately installed thermometer show the correct read-
ing?
– Is the ventilation system working properly?
– Is the appliance set up too close to a heat source?
If none of the above causes apply
and you cannot rectify the fault your-
self, contact the nearest customer
service department stating the type
of appliance
1
, service number
2
and appliance number
3
as in-
dicated on the type plate. The type
plate is located in the refrigerator
compartment on the left-hand side.
Changing over door hinges
Shutting your appliance down
If your appliance is to be shut down for any length of time, switch it
o and disconnect the plug or remove the fuse. Clean the appliance
and leave the door open in order to prevent unpleasant smells.
The appliance complies with the relevant safety regulations and
EC directives 2004/108/EC and 2006/95/EC.
All types and models are subject to continuous improvement and
the manufacturer therefore reserves the right to make modica-
tions to the shape, equipment and technology.
GB
1.
Remove screw from lower hinge
bracket.
2.
Lift door 1, tilt to the right 2 and
remove 3.
4.
Transfer pin to the opposite side of the
door.
5.
Transfer upper hinge components to
the opposite side.
6.
Transfer lower hinge bracket to the
opposite side.
7.
Locate door on upper pin.
8.
Tilt door inwards from the left 1. Se-
cure hinge pin with screw 2.
3.
Transfer handle to the opposite
side.