Filter
Top Products
7
Fastening the appliance in the recess
Once in the recess, secure the appliance to
the body of the unit using the securing
plates (4 x 16 screws).
Then click the covers sup-
plied into place.
Adjusting the refrigerator door
The lateral tilt of the refrigerator door can be adjusted if required.
Undo screws
1
. Adjust the lateral tilt using the grub screw
2
(Allen key A/F 2.5).
Adjusting the front of the drawer
If required, the front of the freezer drawers can be adjusted.
Transfer the screws shown in the illustration (on the left and right
sides of the freezer drawer) individually to the long slots below.
Tighten the screws in the front of the drawer once it is in the right
position.
Side view of the freezer drawer
pulled out
Leveling the appliance
1. Adjust the height of the appliance at the front by twisting the
leveling feet
1
. Use the open-ended spanner provided.
Turn the spanner counterclockwise to raise the appliance front
and clockwise to lower it.
Position the spanner accordingly(
1
).
2. Adjust the height of the appliance at the rear by turning the ad-
justing bolts
2
. Use a 1/4" box spanner or the Torx 25 wrench
provided.
3. Rotate leveling feet
1
until firmly in place against the floor.
WARNING!
To prevent the appliance from tipping forward the level-
ing feet
1
must have contact with the floor.