8
5. Insert the locking pins to block the sup-
ports.
Mounting the ventilation grille
Pull out the bottom freezer drawer.
1. Remove the blue protection film from the dust filter
provided and insert the filter into its opening
in the plinth
. Engage the filter at the
bottom, press down the button
and click into place.
3. Insert the supports for the ventilation grille
on the left and right sides in the motor
compartment.
6. Install the ventilation grille.
The grille has bolts on the inside (see detail in the drawing
below). These bolts must be inserted into the holes of the
supports.
4. The front edge of the brackets
is flush with the front of the
ventilation grille.
Adjust the supports accordingly.
2. Remove the locking pins of
both supports. The supports
are provided with the appli-
ance accessory pack.
7. Adjust the height of the ventilation grille.
• Loosen the grub screws at the front of the grille (Allen key
A/F 2.5).
• Adjust the ventilation grille to the desired height.
• Tighten the grub screws.
1.
2.
7.
3.
4.
6.
5.