Filter
Top Products
A delight in freshness
WF1051 / EWTNes 2956
13
2.
1
2
1.
3
4
4
4
6
6
5
5
5
5
8
4.
3.
4
6
4
6
4
6
7
7
7
7
6.
6.
5.
Fig.E BGENes
INSTALLATION
Only install the winecooler/freezer in a stable
kitchen cabinet that has been properly aligned.
- Mount and fix the handles, depending on your
model and choice.
Unpacking
Unpack the installation kit and check with the pro-
vided parts list if all parts are included.
The part numbers given in the parts list are identical
to the numbers in the respective fi gures.
For installation you will need the following tools:
Included:
- Star Key Torx® 15
- Star Key Torx® 20
- Star Key Torx® 25
- Socket Wrench 8 mm
- Open-end Wrench 10 mm
Not in package:
- Phillips (star) screwdriver
- Level
- Ruler
Figure 16: Installation with Ventilation Grille Set:
1. Screw the installation frame at the top (1) onto
the appliance (2).
2. Place the ventilation grille (3) on this, align
it in the center and secure at the front from
underneath.
3. Slide brackets (4) onto the side installation
frames (5) from above and below.
4. Using the frame (5), screw the brackets onto
the side wall*.
5. Slide the side installation frames (5) upwards
until they are in contact with the underside of
the ventilation grille.
6. Secure the side frames with the adhesive
section (7) to prevent them from sliding down.
Remove the protective film and affix the
adhesive sections over the upper brackets on
the handle and hinge sides.
Figure 16