Filter
Top Products
Mounting the freezer drawer
panels - Figure 23
The panels can be attached to the appliance now.
The upper drawer panel must be mounted first.
1. Pull out the upper freezer drawer and screw on
the panel with three screws at left and right hand
side using the screws as shown in Figure 23.
2. Close the drawer and check the position to the
surrounding cabinet panels. Align the panel in
vertical direction by loosening the screws left
and right. Finally fasten the screws.
To avoid damage to the screws use
the correct screwdriver only. Do not
overtighten.
3. Pull out the lower freezer drawer and fasten the
lower panel in the same way. Align to the upper
drawer panel before fastening the screws finally.
Screw 3.5 x 13 mm
Figure 23
Mounting the refrigerator door
panels - Figures 24 - 31
1. Open the left refrigerator door and hang the
panel on the adjusting bolts (Figure 24).
2. Screw on the hex nuts to the adjusting bolts and
fasten temporarily (Figure 24).
3. Loosen the four cross-head screws of the
bracket and move the panel to the left until it
makes contact with the center rail (Figure 25).
4. Fasten the four cross-head screws (Figure 25).
Figure 24
Figure 25
16
INSTALLATION