Filter
Top Products
5. Close the door and check the height of the
panel.
6. Align the panel in its vertical position if
necessary. Loosen the hex nuts and turn the
adusting bolts using a screwdriver for slotted
screws (Figure 26).
7. Check the vertical position of the panel again
and fasten the hex nuts finally.
Figure 26
Figure 27
To make it possible to fasten the refrigerator
panel at the bottom the soft-stop cylinder must be
dismantled.
8. Stick a small screwdriver under the retaining
clamp and lever out (Figure 27).
9. Grasp the soft-stop cylinder and pull down
(Figure 28).
The soft-stop cylinder retracts in the
detached state.
Figure 28
Figure 29
10. Fasten the refrigerator panel with three screws
(4 x 16 mm) at the bottom (Figure 29).
17
INSTALLATION