Filter
Top Products
Impinger I – Operator Manual
15
Set tension on conveyor belt. The belt should be able to be lifted enough to allow it
to be ¼” (6mm) from the top of the conveyor opening on the oven. Do not over-
tighten the belt.
!
CAUTION:
FINGER REMOVAL AND DISASSEMBLY FOR CLEANING
1. Open door and remove upper fingers. Note any particular placement of fingers that you may have, such as
fully closed, half-closed, or fully open, columnating plates.
2. Remove conveyor and then remove bottom fingers.
3. For finger disassembly, see “Stand and Finger Assembly” section.
4. Reassemble fingers in reverse order with the step of the columnating plate facing downward so it fits under the
lip of the finger housing.
5. Re-install finger in oven. Be sure that they are fully seated over the plenum flanges and the holes are pointing
toward the conveyor.
CONVEYOR REMOVAL FOR CLEANING
CONVEYOR INSTALLATION
1. Remove conveyor chain guard. Remove crumb
pans.
3. Lift right end of conveyor and push in
approximately 3” (76 mm). Remove drive chain.
2. Next, slide the conveyor hold-down clips so the
screw is in the left side of the slot, then rotate
counterclockwise to the up position.
4. Pull conveyor out the right end. Place on table or
work surface.
1. Insert the conveyor through the opening in the right
side. Sprocket should be to the right side of the
conveyor.
2. Slide conveyor through the oven chamber until the
locking bar on driving end of the conveyor is
approximately 2” – 3” (50 – 76 mm) into the oven
chamber. Install drive chain by placing it over the
driving sprocket and placing it over the conveyor
sprocket.
3. Lift conveyor just enough to allow you to pull the
conveyor toward you until the locking bar is outside of
the oven cavity, at the same time push the conveyor
downward so that the bar locks on the outside of the
oven wall. Next, slide the conveyor hold-down clips so
the screw head is in the left side of the slot, rotate clip
clockwise to down position and slide so the screw head
is in right side of the slot to lock.
4
.Reinsta
ll conveyor crumb pans and chain guard cover.
CONVEYOR REMOVAL
CONVEYOR DRIVE
SPROCKET
DRIVE CHAIN
DRIVE
MOTOR
SPROCKET
CONVEYOR
HOLD DOWN
CLIP SHOWN
IN DOWN
AND LOCKED
POSITION
CONVEYOR
HOLD DOWN
CLIP SHOWN
IN DOWN
AND LOCKED
POSITION
CONVEYOR REPLACEMENT
DRIVE
MOTOR
SPROCKET
DRIVE CHAIN
½” SAG
CONVEYOR DRIVE
SPROCKET