Filter
Top Products
Impinger 3255 – Operator Manual
11
FINGER HOUSING BAFFLE PLATE ADJUSTEMENTS
The finger housing has a baffle mounted inside to balance the air flow to the rear and front of the oven. If the
product is cooking more or less in the rear of the oven than in the front, it is possible the finger housing baffle needs
to be adjusted. If it is deemed necessary to adjust the air balancing baffle, be sure to adjust all ten (10) finger
housing to exactly the same opening. Determine if more air (heat) is required at front or rear of oven then open or
close off that air by bending the baffle in the proper direction. For additional information on how to adjust the Finger
Housing Baffle Plate, contact the Lincoln Technical Service Department at (800) 678-9511.
10. Install finger in the oven by sliding
it over the plenum flange and
setting the front bracket. BE SURE
THAT THE FINGER SETS
SQUARELY OVER THE PLENUM
FLANGES AND THE HOLES
POINT IN THE PROPER
DIRECTION. Top fingers point
down, bottom fingers point up.
11. Repeat step 10 until all ten (10)
fingers are installed.
Install conveyor and crumb pans
before operation. See page 17 for
conveyor installation instructions.
12. Attach Motor Cover as shown with
bolts provided.