Filter
Top Products
K2187-2 (COOL ARC® 40 230V International)
Via Continental European (SCHUKO)- PRONG PLUG
220-240VAC 50/60 Hz 1 Phase
1.3-1.7 Amps
2.0-2.4 Amps
60 psi (414 kPa) (4.14 bar)Max.
1.66 gal/min. (6.28 liter/min) Max.
53-57 psi (365-393 kPa)
.45-.60 gal/min. (1.7-2.3 liter/min)
2.0 ga. (7.6 liters)
For Use Above Freezing: Use Clean tap, distilled or de-ionized water.
For Use Below Freezing: Use
50% water and 50% pure ethylene glycol
(reagent or industrial grade) mixture.
DO NOT USE: Automotive anti-freeze that contains rust inhibitors or leak stoppers.
These coolants will damage the pump and block the small internal passageways of the
heat exchanger, affecting cooling performance. To acquire the proper coolant contact
a local welding distributor.
DO NOT USE: Pre-packaged welding industry coolants. These coolants may contain
oil-based substances, which attack the plastic components of the cooler. Once added
to the cooler, these substances are impossible to purge from the water lines and heat
exchanger.
46.5 lbs. (21.1 kg)
61.2 lbs. (27.8 kg)
9.03 in. (229.4mm)
9.10 in. (231.1mm)
31.99 in. (812.6mm)
34.26 in. (870.2mm)
A-1
INSTALLATION
COOL ARC® 40
A-1
Product No. / Model
Input
Current Draw @ 60Hz Input
Current Draw @ 50Hz Input
Maximum Operating Pressure and Flow Rate
(Open Flow, Without Welding Torch Restriction)
Typical Operating Pressure and Flow Rate
(With Welding Torch Restriction)
Reservoir Size
Recommended Coolant
Shipping
Weight
Reservoir
Full (Water)
L
W
Dimensions
H (Top Face)
H Top Handle)
TECHNICAL SPECIFICATIONS – COOL ARC® 40
EXPLANATION OF SYMBOLS THAT APPEAR ON THIS EQUIPMENT
OFFOFF
O
ON