Filter
Top Products
MKG SERIES GAS GRIDDLE INSTALLATION & OPERATION
3
1.5. INSTALLATION, SET UP:
The installation of this appliance MUST conform to local codes. In the absence of local codes, the installation must
conform to the National Fuel Gas Code, ANSI Z223.1; Natural Gas Installation Code, CAN/CGA-B149.1; or Propane
Installation Code, CAN/CGA-B149.2 as applicable.
A. Uncrate appliance and locate installation accessories shipped with the appliance.
1.5.1. For Counter Use With Legs:
CAUTION
To prevent equipment damage, DO NOT tilt your MagiKitch'n
griddle on only two legs, or on its sides.
A. (See picture at right) A set of 4” legs is shipped with the
appliance (unless appliance was specifically ordered
without legs). A threaded receptacle is located near each
corner of the underside of the base of the appliance, on
appliances 48" and wider there are threaded receptacles
in the front and rear center of the base. Each leg has a
similar mating thread. Raise appliance sufficiently to
allow legs to be screwed tightly into receptacles. The
appliance can be leveled by adjusting the feet at the
bottom of the leg assembly. This can be done by turning
the foot in or out to lower or raise each corner as
needed.
NOTICE
4" Legs should not to be used with the optional Equipment Stand.
CAUTION
The appliance must be level to perform properly. Failure to level unit may result in improper combustion and performance of
the appliance.
1.5.2. For Counter Use Without Legs:
A. (See picture at right) The appliance must be sealed to the
counter to comply with applicable sanitation standards. A
bead of silicone sealant, approximately ½ inch wide, is to
be applied to the bottom of the unit approximately ¼” in
from the front, back and side edges. We suggest Dow
Corning ®, GE ® or Permatex ® silicone ‘RTV’ adhesive
sealant or equivalent. (See NSF Basic Criteria C-2 for
details).