Filter
Top Products
MKG SERIES GAS GRIDDLE INSTALLATION & OPERATION
4
1.5.3. For Use on Optional Equipment Stand:
ATTENTION
Rear mounting brackets should be installed
to the Equipment Stand prior to placing griddle on the stand.
CAUTION
Only two of the four supplied casters are equipped with a locking
feature. Install the griddle so that the two locking casters are at the
front of the unit. The casters should be LOCKED before the unit is
placed into operation.
(See pictures this page). To mount the griddle to the stand,
locate joining kit supplied with stand. The joining kit should
include (2) rear mounting brackets, and (4) 1/2" mounting bolts.
To mount the griddle to the equipment perform the following
steps:
NOTICE
The larger units have 6 threaded receiving holes, but require
only the four 1/2" bolts on each corner to mount the griddle.
Step 1- Remove (4) existing 1/4-20 nuts and bolts from
the rear corners of the equipment stand.
Step 2- Align the 2 bolt holes on the rear corners of the
stand with the 2 bolt holes on the rear mounting brackets.
Orient the brackets as shown in the pictures on this page.
Step 3- Install the provided rear mounting brackets (2) to
the rear corners by using the existing 1/4-20 hardware that
were removed in step 1, tighten securely.
Step 4- Carefully place the griddle on the equipment
stand.
Step 5- Once the griddle is on the stand position the
griddle on the stand so that the front edge of the base is
flush with the front of the equipment stand. If the griddle
is the only appliance to be mounted on the stand, then
both sides of the griddle should be flush with the sides of
the equipment stand.
Step 6- When positioned properly, the threaded receiving
holes in the griddle base should be aligned with mating
clearance holes at the front of the equipment stand, and
with the clearance holes in the rear mounting brackets.
Install the provided 1/2" bolts and tighten securely.
NOTICE
This appliance may only be installed with casters provided by
the manufacturer. When installed with casters, a gas
connection complying with ANSI Z21.69/CGA-6.16 and a
quick disconnect device complying with ANSI Z21.41/CAN 1-
6.9. It must also be installed with a restraining device to
guard against putting any strain on the gas connections when
the unit is moved.