Filter
Top Products
-11-
Cleaning and
Maintenance
IMPORTANT: Your Blending Jar, Shaving and Blending Blades are subject to
wear during normal use. Always inspect for nicks, chips, or cracks. Always
inspect for broken, cracked, or loose blades. If the Jar or Shaving and Blending
Blades are damaged, do not use. Call our toll-free customer service number,
1-877-689-2737, to obtain replacement parts.
1. Make sure Battery is removed. Place on a clean dry
surface. Turn the unit so the back is facing you. Remove
the Ice Reservoir Lid by turning clockwise to the unlock
position (Figure 1).
2. To remove the Ice Reservoir, grasp the reservoir with
your hand, turn clockwise, and lift to remove (Figure 2).
Note the location of the Shaving Blade inside the
Ice Hopper (Figure 2).
WARNING: DO NOT PLACE FINGERS INSIDE THE
ICE HOPPER NEAR THE SHAVING BLADE. BLADE
IS SHARP HANDLE CAREFULLY.
NOTE: TO REASSEMBLE, INSTALL ICE RESERVOIR
TO THE UNIT FIRST, THEN ATTACH ICE RESERVOIR LID.
3. To Remove the Shaving Paddle, press the button located
underneath the Ice Chute. If the button cannot be
pressed, rotate the Shaving Paddle for a half turn and
retry (Figure 3).
While pressing the button, rotate the Shaving Paddle
counter-clockwise (to the left) by placing fi ngers in the
ridges of the Shaving Paddle and unscrew. This will
expose the Ice Hopper and Shaving Blade.
To re-assemble the Shaving Paddle, simply replace it
into the threaded insert and rotate clockwise. Hand
tighten only (Figure 4).
SHAVING
BLADE
Figr 1
Figr 2
Figr 3
Figr 4