Filter
Top Products
How to Clean and
Maintain Your beverage center
Condenser: The condenser tubing inside the cabinet
does not require frequent cleaning; however, satis-
factory cooling depends on adequate ventilation over
the coils. Be sure that nothing obstructs the required
air flow openings in front of the cabinet. At least once
or twice a year brush or vacuum lint and dirt from the
condenser for efficient performance by unscrewing
the grille on the bottom front of the cabinet.
Cabinet: The painted cabinet can be washed with
mild soap and water and thoroughly rinsed with clear
water. Never use abrasive scouring powders.
Interior: Wash interior compartment with mild soap
and water. Do not use an abrasive powder, solvent,
polish cleaner or undiluted detergent.
Glass Door: Use a glass cleaner or mild soap and
water and soft cloth to clean the glass door model.
Do not use any abrasive powders.
Door Gasket: The vinyl gasket may be cleaned with
mild soap and water, a baking soda solution or a mild
scouring powder.
Light Tube Replacement: WARNING! DISCONNECT
THE POWER CORD BEFORE ATTEMPTING LIGHT
TUBE HOUSING ASSEMBLY REPLACEMENT.
Failure to do so may result in an electrical shock that
could severely injure you.
This product uses one, 6 watt light tube to illuminate
the interior of the beverage center. The light tube is a
very reliable electrical component, but should it not
function properly, please call the dealer you purchased
your beverage center from for a replacement light tube
housing assembly. Use only an original equipment
light tube housing assembly from your dealer or man-
ufacturer.
Using a
5
/16” hex-head driver, remove the two hex-
head screws holding the old light tube housing
assembly in place. Disconnect the electrical plug
from the cabinet’s electrical receptacle and discard
the old light tube housing assembly. Reconnect the
electrical plug of the new light tube housing assem-
bly to the cabinet’s electrical receptacle. Make sure
it is secure and fully inserted.
Using the
5
/16” hex-head driver, resecure the two
hex-head screws back into their original positions to
fasten the light tube housing assembly to the top of
the cabinet.
Re-use the original two screws to secure the light tube
housing in place. Plug the beverage center into the
electrical socket. Check to see if the light tubes oper-
ate properly. Your light tube’s replacement is complete.
The light tubes are not covered by your guarantee. A
replacement light tube housing can be obtained from
your service provider or from Marvel Industries.
What to do in
the Event of a Power Failure
Most power failures are corrected within two hours
and will not affect the unit’s temperature providing you
minimize the number of door openings while the
power is off. A gradual rise in temperature should not
have any adverse effect on your wine if power is out
for a longer period. If it is extremely hot, you may
want to move your wines to the coolest location you
can find until power is restored.
Appliance Features
Adjustable Temperature Control: Please see “how
to Operate Your Refrigerated Beverage Center” on
page two.
Interior Light and Switch: The interior light makes it
easy to view the contents of your refrigerator. When the
switch is in the “OFF”
position, the light will
come on when the door
is opened. When the
switch is pushed such
that the “red” portion of
the rocker is showing, the
switch is in the “on” position and the interior light will
stay on continuously. Remember to turn the off the light
when it is no longer needed.
3