Filter
Top Products
1.234" (31.3mm)
.991" (25.2mm)
NOTE
FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS
Figure 9
18
If your refrigerator has a door
lock proceed to Step 7. If your
refrigerator does not have a
door lock proceed to Step 9.
Step 7: Mark and drill lock hole.
Locate and mark with a pencil the location of the lock hole
on the overlay panel, this is the hole in the top corner of
the handle side of the door. Remove the clamp and re-
move the overlay panel from the door. On the backside of
the panel where you marked the lock location drill a
13
⁄16"
(20.5mm) diameter counter bore
7
⁄16" (11.0mm) deep into
the overlay panel. Drill a
15
⁄32" (12.0mm) diameter hole
through the overlay panel centered on the counter bore be-
ing careful not to splinter the wood on the face side of the
panel. (See Figure 10).
Overlay Panel
Door
Top Hinge
Adapter
Hole in
hinge
adapter
Hole in bottom
hinge adapter
Figure 8
the surrounding cabinetry. If your handle attaches from the
back-side of the custom panel, locate the mounting holes
while the panel is attached to the door and cabinet. After
the panel is removed from the door, drill the mounting holes
from the front, to the recommended diameter of the handle
manufacturer. Counter bore the back-side of the panel so
the screw heads do not interfere with the surface of the
door.
Table C
Step 6: Drill panel mounting holes
Re-clamp the panel to the door per step 5 and drill the
screw pilot holes for attaching the overlay panel to the door.
Select the size of the hole from Table C. Be careful not to
drill the pilot holes through the overlay panel,
1
⁄2" (12.7mm)
deep for
3
⁄4" (19mm) and
5
⁄8" (15.7mm) panels.
Material Type #8 Wood Screw
Hardwood
1
⁄8" (3.2mm) Diameter. Pilot Hole
Softwood
7
⁄64 (2.8mm) Diameter. Pilot Hole