Filter
Top Products
5-22 16021814 Rev. 0 ©2002 Maytag Appliance Sales Company
Wax Motor Detergent / Rinse Dispenser
Removal
1. Disconnect power to the machine.
2. Remove the Inner Door Panel. (See paragraph Inner
Door Panel removal).
3. Remove the 6 mounting screws securing the
Detergent Dispenser mounting bracket.
4. To remove the Wax Motor, pry out of retainer.
NOTE: It is not necessary to remove Detergent
Dispenser before removing Wax Motor.
Service and Disassembly Procedures
!
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit and discharge
capacitor through a 10,000 ohm resistor before attempting to service, unless test procedures require power to be
connected. Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Vent
The Vent is located on the Inner Door Panel to allow
moisture to be vented outside of the Dishwasher during
the dry cycle.
Removal
1. Disconnect power to the machine.
2. Remove the Inner Door Panel. (See paragraph Inner
Door Panel removal).
3. Rotate Vent Cover counter clockwise 1/4 turn and lift
off.
Wire Cover
The Wire Cover retains the Wire Harness to the bottom of
the Tub. It is located on the bottom side of the Tub.
Removal
1. Disconnect power to the machine.
2. Remove Front Support and Toe Panel. (See paragraph
Front Support and Toe Panel removal).
3. Remove 2 screws securing Wire Cover to bottom of
Tub.
4. Feed Wire Harness out of bracket.