Filter
Top Products
©2002 Maytag Appliance Sales Company 16021814 Rev. 0 5-27
Over Pressure Filter
The purpose of the Over Pressure Filter is to filter
sediment missed by the lower filter rather than circulating
it back through the wash.
Removal
1. Spread locking tabs.
2. Rotate filter down and remove from manifold.
Top Wash Arm
Removal
1. Spread locking tabs and remove Wash Arm Retainer.
Door Spring and Component Replacement
NOTE: Always point spring hooks toward the Dishwasher.
1. Disconnect power to the machine.
2. Remove Dishwasher from cabinets.
3. Attach Door Cable Link to Door Hinge.
4. Attach Cable to Cable Link.
5. Route Cable under Cable Roller.
6. Attach Cable to short hook of Spring.
7. Place large hook end of Spring into Spring Adjustment
Bracket in proper location.
NOTE: To replace Cable Bracket, remove 2 Torx™
screws securing bracket to frame. See
procedure above for reassembly of Spring and
Cable.
Service and Disassembly Procedures
!
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit and discharge
capacitor through a 10,000 ohm resistor before attempting to service, unless test procedures require power to be
connected. Ensure all ground wires are connected before certifying unit as repaired and/or operational.