Filter
Top Products
10 INSTALLATION AND MAINTENANCE MANUAL PUBLICATION DATE Sep 05 100646
6kg / 13lb 7kg / 16lb 10kg / 22lb 16kg / 36lb
X1
660 mm / 25.98“ 660 mm / 25.98“ 660 mm / 25.98“ 830 mm / 32.7“
X2
560 mm / 22.05“ 560 mm / 22.05“ 560 mm / 22.05“ 715 mm / 28.1“
X3
50 mm / 1.97“ 50 mm / 1.97“ 50 mm / 1.97“ 57.5 mm / 2.26“
X4
685 mm / 26.97“ 685 mm / 26.97“ 785 mm / 30.91“ 960 mm / 37.8“
X5
455 mm / 17.91“ 455 mm / 17.91“ 565 mm / 22.24“ 815 mm / 32.09“
X6
130 mm / 5.12“ 130 mm / 5.12“ 130 mm / 5.12“ 80 mm / 3.15“
X7
110 mm / 4.33“ 110 mm / 4.33“ 110 mm / 4.33“ 130 mm / 5.12“
Tab 4.3.3. Distances anchoring bolts
4.3.4. LEVELING THE MACHINE
WARNING !
THE MACHINE MUST RELIABLY REST IN ALL FOUR CORNERS OF THE MACHINE!
THE MACHINE MAY NOT ROCK.
THE MACHINE MUST BE IN WATER LEVELLED POSITION.
MACHINES 6kg / 13lb, 7kg / 16lb, 10kg / 22lb
The rubber feet are screwed on the bottom of the machine frame and are adjustable with a wrench size
13mm / 0.5" and 17mm / 0.7". Check the position of the top of the machine by a water level and adjust
machine legs, fig.3.1, pos.11. Adjust the four rubber feet until the machine is leveled and tighten the nuts
M10 back to the bottom of the frame.
MACHINES 16kg / 36lb
The 16kg / 36lb machines don’t have rubber feet for adjustment to water level. When it is necessary use
thin hard plates of 10x10cm / 3.93“x3.93“with thickness of 1mm / 0.04“ and place them under the frame
corner of the lowest position. Use more of them until the machines stands water level. It is always advisable
to bolt down this machine after leveling. Take care that the machine is in the lowest possible position.
If the machine with his cabinet rocks can it damage the machine cabinet. The manufacturer is not responsible
for consequences caused by a wrong installation.
4.4. SHIPPING BARS
WARNING !
DO NOT TRY TO OPERATE THE MACHINE WITHOUT REMOVING THE SHIPPING BARS
DO NOT TRANSPORT THE MACHINE WITHOUT SHIPPING BARS MOUNTED.
OTHERWISE THIS CAN LEAD TO INJURY TO PEOPLE AND CAN DAMAGE THE MACHINE.
The machine is blocked for transport. This eliminates all possible movement of the tub during transportation.
There are 3 striking shipping bars which must be removed before putting the machine into operation.
1. Remove fixation plate front, fig. 4.4. pos. 1.
2. Remove fixation plate rear right, fig. 4.4. pos. 2.
3. Remove fixation plate rear left, fig. 4.4. pos. 2.
IMPORTANT : UNSCREW ONLY THE NUTS WHERE INDICATED !
!
!