Filter
Top Products
Z40EdwardsStreetSE
C',eveiand.]enness_e373il
Tel:_23472-3333
Fax:423,i78670
NOTE: Check the vertical handle position by using one short perimeter trim piece. Using the trim piece as a
visual guide, first place it directly above the chromed handle endcap on the freezer door. Open and sight down
the top edge of the door panel If light can be seen between the top edge of the door panel and the foam
adhesive on the perimeter trim, the upper chromed endcap on the handle will need to be adiusted downward
until foam tape makes contact. If light cannot be seen, use the same procedure to check the refrigerator door.
If no adjustment is needed, proceed to Step 6.
If the upper portion of the handles need attjustment, proceed according to the following instructions:
TOP EDGE OF DOOR: With a phillips screwdriver, proceed to remove the upper chromed endcap.
Remove the top plastic handle trim extension. File off the top of the trim lock the amount necessary to elimi-
nate the light previously seen. Do not remove more than 1/32". Reinstall the components that were removed
and check the trim fit.
£ND CAP _ z T
5C_W5 _ _ END CAPS
LI, Xr NSIONS
_ " LOCKS
If you are satisfied with the fit, proceed to Step 6.
6. Using black tape provided in kit. cut appropriate lengths to be applied to the door panel at the top and bot-
tom of the hahdle opening on the freezer and refrigerator doors. On dispenser models, remove the screw from
the bottom of the dispenser escutcheon and discard. Move the selector switch to "ice" and slide the escutcheon
frame to the left to remove it. Apply tape as shown for dispenser. Reinstall the escutcheon frame.
_ltt T_P[NG HJ.NDL E.S
d_EX_E.t_SIO_'_CAP
-_ AR[&$ _._kMEON BOTH
_MATI-AG A_mlra| _| mJ=:N_-A;# "_:_a_jic Chef