Filter
Top Products
,2,ustcrnerSepzice ._111_ _
240EdwardsStrae[,SE
Cleveiand,Tennessee2731T
Tel:42_-472-%%
Fax:423-,178-8710
19. Place upper H-trim piece onto panel and capture with top trim piece. Before removing the tape backing,
check that the top trim is flat against the top of the door, If the H-trim holds the tape away from the door,
remove the panel and shorten the panel to fit. Check the side trim piece the same way at this time. Using the
6 inch trim piece provided as a guide to form tight corners, install top trim to clamp H-trim against the face of
the door. Pull tabs previously creased to expose tape adhesive to door. Press down firmly along entire length
of part to insure proper bond. Proceed to install bottom trim using the 6 inch trim piece as a guide.
Ptlt//,_.tt_.4lql111_
i
A
X-TRIM p I
I
TOP _F tlOOR
P/_I_aE[. -
NOTE: One side trim piece has a magnet on the back and one H-trim side pieces has a notch to clear the dis-
penser escutcheon. Save these trim pieces for the freezer door.
20. Follow instructions outtined in Step 17 before you proceed to install side trim pieces, For the right side,
place the H-trim side piece onto the panel edge. Capture the H-trim piece with the side perimeter trim. Make
sure you form tight corners with the installed top and bottom trim. Pull tabs previously creased to expose
adhesive to the door panel side. Press firmly along the entire length of the part to insure proper bonding.
21. Install the left side trim piece (with no H-trim as outlined in Step 20 to clamp down filler strip.
["_ ,MA'/L&G Adnllra171 -'nere,J _ .'_N -,_ "_klagic Chef