Filter
Top Products
C0 0merSe ic
240EdwardsStreet,SE
C',evelanc,Tennessee37311
Tel:423-_72-3333
Fax:429--t78-6718
INSTALLATION OF FREEZER DECORATIVE PANEL
22. If you have a non-dispenser model, basically follow the same procedures as outlined in Steps 8 through 21
to install the freezer door decorator panel and trim, ten proceed to Step 38. If you have a dispenser model,
continue with Step 22.
INSTALLATION OF FILLER STRIP
23. Peel back three to four inches of the protective backing and crease to form pull tab on the end of the filler
strip that will be placed toward the top of the freezer door.
EadToward
TopOfDoor
24. Position filler strip with "soft nose" against the handle side on the right side of the door. Apply pressure to
the "hard end" of the filler strip to slightly compress the "soft nose" against the handle. Then press down
firmly to insure proper bonding.
PL'LL
!
TOPt)FOCOR ).
Er-dCa;re.s.,i...ti. tt,_is i
|
PrL_ _l_vrl T'o [n_urtz
pTrloer _,,odin,_' !t) O.,_e
IMPORTANT: Once adhesive bonds to the door panel, it cannot be removed. Make sure you align filler strip
properly as you work towards the bottom of door.
25. As you work toward the bottom of the door, pull tape backing to expose adhesive to the door panel.
_'_ MA_rAG &dmlral _J "Pi_'l'zUENN .#JR _#"_(ji¢:C,'_e|