Filter
Top Products
16
Directions for reversing the dryer door:
1. Carefully remove the hinge hole covers with a flathead screwdriver. Move the door catch cover to the
opposite side
.
2. While supporting the door, remove the 4 counter sunk hinge screws which secure the hinges to the
cabinet.
When removing the 4 counter sunk hinge screws, alternate between the top and bottom hinge to
prevent bending the hinge.
3. Mo
ve the follo
wing par
ts to the opposite side of the door: 2 hinges, 4 counter sunk hinge screws, 4 door
screws, door strike and screw; inner door cover plate and screw.
4.
Attach the door to the opposite side of the cabinet using the 4 counter sunk hinge screws. (See below).
Screw the lower counter sunk hinge screw in first. This will help to align the door and hinges.
5.
Replace the hinge hole co
vers to the opposite side
.
6.
Close the door and check to make sure the dryer operates properly.
I
nstructions for replacing the bulb:
1. Unplug or disconnect the stacked unit from the
electrical power supply.
2. Open the door and use a Phillips screwdriver to
remove the screw attaching the lens to the tumbler
front.
3. Remove lens cover by pulling cover toward center
of tumbler.
4. Rotate the bulb counter-clockwise to remove from
socket.
5. Replace the bulb with a 120 volt, 10 watt maximum
candelabra base light bulb.
6. Turn the light bulb clockwise into socket.
7. Replace lens cover by hooking plastic tabs into
tumbler front below the light housing.
8. Reinstall the screw into the lens cover screw hole.
9. Reconnect stacked unit to power supply.
RR
EPLACING DRYER DRUM LIGHT
REVERSING THE DRYER DOOR
NOTE: The amount of water used to wash loads of laundry will vary with each load.The Maytag Neptune
®
Super Stack
TM
washer uses an IntelliFill
TM
device to provide the appropriate amount of water for efficient cleaning
performance and conservation of water and energy.
WW
ATER USE