21
Leaks Water
Is Noisy
Fills with
the Wrong
Temperature
Water
Cycle Selector
Knob Advances
Through “OFF”
Tub is
Completely
Full of Suds
Stops
• Plug cord into live electrical outlet.
• Check fuse or reset circuit breaker.
• Turn the control dial to proper cycle and push the
START/STOP button to
start the clothes washer. Be sure the buttons are fully depressed.
• Close door and push the
START/STOP button to start the clothes washer.
For your safety, washer will not tumble or spin unless door is closed.
• This may be a pause or soak period in the cycle. Wait briefly and it may continue
the cycle.
• Check for low water pressure.Try not to run a shower and/or dishwasher at the
same time.
• Make sure hose connections are tight.
• Make sure end of drain hose is correctly inserted and secured to drain facility.
• Avoid overloading.
• Clothes washer should be leveled properly as outlined in Installation Instructions.
• Weak floors can cause vibration and walking.
• Be sure rubber feet are installed on leveling legs.
• Check that the leveling leg lock nuts are tightened.
• Turn both faucets on fully.
•
Check that the temperature selector button is fully depressed.
• Make sure temperature selection is correct.
• Make sure hoses are connected to correct faucets and inlet connections. Flush
water line before filling washer.
• Check the water heater. It should be set to deliver a minimum 120°F (49°C) hot
water at the tap. Also check water heater capacity and recovery rate.
•
Disconnect hoses and clean scr
eens.
Hose filter scr
eens ma
y be plugged.
• Extra rinse option is selected.
• Run the clothes washer through another complete cycle using cold water.
• Reduce detergent amount for that specific load size and soil level.
• Use high efficiency or low sudsing detergent specially formulated for front load
washers.
• See “Won’t Spin or Drain” section on page 20.
TT
ROUBLESHOOTING - WASHER
Check these points if your clothes washer...