Filter
Top Products
25
Oven smokes
excessively during
broiling.
Oven will not
self-clean.
Oven did not clean
properly.
Oven door will not
unlock after
self-clean cycle.
Moisture condensation
collects on oven window.
There is a strong odor or
light smoke when oven
is turned on.
A fan sound can be
heard (select models).
“F” plus a number
appears in display.
Before You Call For Service (continued)
• Food too close to flame. See page 15 for more information.
• Broiler insert covered with aluminum foil.
• Excess fat not trimmed from meat prior to broiling.
• A soiled broiler pan was used.
• Check to make sure controls are properly set.
• Check to make sure the cycle is not set for a delayed start.
• Check if door is closed.
• Longer cleaning time may be needed.
• Excessive spillovers, especially sugary and or acid foods, were not removed prior to the
self-clean cycle.
• Oven interior is still hot. Allow about one hour for the oven to cool after the completion
of a self-clean cycle. The door can be opened when the LOCK indicator word is not
displayed.
• This is normal when cooking food high in moisture.
• Excessive moisture was used when cleaning the window.
• This is normal for a new range and will disappear after a few uses. Initiating a clean cycle
will “burn off” the smells more quickly.
• Excessive food soils on the oven bottom. Use a self-clean cycle.
• This is the cooling fan and is normal. The fan will continue to run after use until
the oven cools.
• This is called a fault code. If a fault code appears in the display and beeps sound,
press the CANCEL pad. If the fault code and beeps continue, disconnect power
to the appliance. Wait a few minutes, then reconnect power. If fault code and beeps
still continue, disconnect power to the appliance and call an authorized servicer.
• If the oven is heavily soiled, excessive flare-ups may result in a fault code during
a clean cycle. Press CANCEL pad and allow the oven to cool for one hour, then
reset the clean cycle. If the fault code and beeps still continue, disconnect power
to the appliance and call an authorized servicer.