Filter
Top Products
the heating plate.
4. Keep your hands and the cord away
from hot parts of the coffee maker
during its operation.
5. Never clean with scouring powders
or hard implements.
HOUSEHOLD USE ONLY
KNOW YOUR COFFEE MAKER
BEFORE THE FIRST USE
We recommend that you get familiar with
all parts of your Coffee Maker before
operating it, with the unit unplugged.
Begin by inserting the metal filter into
the filter holder (Fig.1), fit the filter into
the brewing head, and remove and
replace the boiler cap. Try the on/off
buttons and steam controller, and check
out all the parts of the coffee maker as
well. Wash all loose parts in warm soapy
water, rinse thoroughly and dry.
To ensure the first cup of coffee tastes
excellent, you should rinse the coffee
maker with warm water as follows:
1. Add water into the tank (Fig.2)
(for drip filter coffee
) to the max
capacity and operate the appliance
per steps (1-5) of section “make drip
filter coffee” (Do not use filter coffee
powder for this first time use). Repeat
it for several times to clean the
appliance.
2. Add fresh water into the boiler
unit(Fig.3) (for espresso coffee)
to the max capacity and operate
the coffee maker per steps (1-9) of
section “make espresso coffee” and
section of “make cappuccino coffee”,
but do not add coffee powder, repeat
it several times.
CAUTION – PRESSURE
It is important to remember to NEVER
open the boiler unit cap or remove the
filter holder while your coffee maker is
turned “on”, or as long as there is
pressure in the boiler unit.
Please follow the instructions listed
below to see if the machine is still under
pressure. These safety precautions
should be followed while your coffee
maker is in use and 10 – 15 minutes after
the last use of the machine.
1. Make sure the coffee maker is in the
“off” position.
2. Unplug the coffee maker from the
wall socket.
3. Hold a pitcher with cold water
underneath the steam nozzle and
insert the nozzle into the pitcher
(Fig.4).
4. Once the steam nozzle is immersed
in the pitcher of water, turn the steam
knob in an anti clockwise direction
to open the steam nozzle. Continue
this procedure until no more steam
comes out of the steam nozzle.
5. Turn the steam control knob to the
clockwise direction to close the
steam nozzle.
6. Now you can remove the boiler unit
cap and the filter holder.
Incase there is still water in the boiler
unit, remove the glass jugs and
drip tray, then turn the coffee maker
upside down to empty any remaining
water in the boiler unit.
MAKE DRIP FILTER COFFEE
1. Open the tank cover (for drip filter
coffee) and pour cold drinking water
into water tank (Fig.2) according to
the gauge. Respect the MAX level
indicator. Purified drinking water
provides a better taste and flavour of
coffee.
2. Place the permanent nylon filter into
the funnel (Fig. 5) and make sure it is
assembled correctly. If the funnel is
not inserted correctly the tank cover
can not be closed.
3. Add ground coffee into the
MW_EX29002_Palermo_IM.indd 5MW_EX29002_Palermo_IM.indd 5 10/29/2008 12:05:32 PM10/29/2008 12:05:32 PM