Filter
Top Products
For the section of making drip filter
coffee
Note: the switch referring on the
following section is the switch for drip
filter coffee.
1. Fill the tank with water and descaler
to the MAX level (Approximate 1.25L,
the scale of water to descaler is 4:1).
Please use “household descaler”.
You can also use citric acid instead
of descaler (the one hundred parts of
water and three parts of citric acid).
Tip: leave the solution in the tank for
15 minutes before brewing.
Note: Descale without using coffee
powder.
2. Place the large jug onto warming
plate and pay attention to let the
centre of large jug to align with that
of brewing basket.
3. Pressing the switch to the “I”
position, the indicator will be
illuminated. After a while, water will
drip out automatically.
4. After the coffee maker has
percolated the equivalent of one cup,
press the switch to the “O” position
to stop the water.
5. Leave the solution to work for 15
minutes, and then repeat the steps
3-5 again.
6. Turn the appliance on by pressing
the switch to the “I” position and run
off the water until the water tank is
completely empty.
7. Rinse by operating the coffee maker
with clean water at least 3 times.
For the section of making espresso
coffee
Note: the switch being referred to in the
following section is the switch for the
espresso coffee.
1. To make sure your coffee maker is
operating efficiently, and producing
the best flavour of coffee, the internal
piping requires periodic cleaning.
You should clean away the mineral
deposits every 2-3 months.
2. Fill the boiler unit with water
and descaler to the MAX level
(Approximate 0.24L, the scale of
water to descaler is 4:1). Please use
“household descaler”. You can also
use citric acid instead of descaler
(the one hundred parts of water
and three parts of citric acid). Tip:
leave the solution in the boiler for 15
minutes before brewing.
3. Brew the water according to the
program of making espresso coffee
without coffee powder in the filter.
4. Turn the brew strength control knob
to “STRONG” or “LIGHT” position,
then turn the switch on by pressing it
to the “I” position and approximately
3 min later the water will flow out.
After making 2 espresso sized cups
of hot water, turn off the switch by
pressing it to the “O” position.
5. Turn brew strength control knob
to the “STEAM” position. Press
the switch to the “I” position. Wait
approximately 3 minutes to generate
the steam and release the steam for
approximately 2 minutes. Afterwards,
turn off the switch by pressing it to
the “O” position.
6. Restart the unit and repeat steps 3-5
at least 3 times, but be sure to re-fill
with water.
7. Then turn the brew strength control
knob to the “STRONG” or “LIGHT”
position, and brew until no descaler
is left.
8. Rinse the system by repeating steps
3-5 with clean water. Repeat this
3 times until no water is left in the
boiler unit.
9. Repeat step 8 at least 3 times to
make sure steam pipe is clean.
MW_EX29002_Palermo_IM.indd 9MW_EX29002_Palermo_IM.indd 9 10/29/2008 12:05:32 PM10/29/2008 12:05:32 PM