Filter
Top Products
3
English
ASSEMBLY AND USE - JUICER
• Carefully unpack unit and examine all packaging to be sure
all parts are included.
• Place Motor Base on a at, stable, anti-slip surface.
• Place the Juice Collector on the motor base. It must
noticeably lock into place.
• Place the Filter Sieve on motor drive coupling of Motor Base and
press rmly until it locks into position on the Juice Collector. Hold
Filter Basket by the outer rim and do not touch the cutting blades.
• Place Lid onto Juice Collector with opening of Lid facing
opposite side of spout.
• Lift both Retaining Brackets up and hook into slots
provided in the Lid. Then press lower part of bracket to
snap into locking position. If brackets are not locked into
position the product will not function.
• Place the Pulp Container under the opening of Lid. Tilt the
assembly slightly to t the container under the lip of Juice Collector.
• Place Juice Cup under spout.
• Place Food Pusher into food chute located on Juicer Lid.
• Be sure On/Off switch is “OFF” position before plugging into 120 volt outlet.
• Do not operate continuously for more than 3 minutes, allow 30 seconds to cool.
• Only use the Food Pusher to push food into the juicer. Do not use other utensils such
as a spoon or the like. IMPORTANT - NEVER INSERT FINGERS INTO FOOD INTO
CHUTE WHILE UNIT IS OPERATING.
• Set the desired speed setting. “1” for softer foods, “2” for harder foods. “P” for pulse.
• Insert food into the food chute, while using food pusher, push food into the lter sieve.
Repeat this process until desired amount of juice is extracted.
• Do not use frozen foods, foods with bones, pits and seeds or foods that have spoiled.
• Switch unit to “O” - OFF and clear the Pulp Collector regularly.
CLEANING INSTRUCTIONS - JUICER
Always unplug unit from outlet. before cleaning.
Motor Base:
• Wipe with damp cloth and dry. Do not immerse in water or other liquids. Do not use
abrasive cleansers.
Filter Sieve:
• If the lter sieve is too tight to remove, it will loosen up in a few minutes when cooled.
• Some foods will discolor the lter sieve, rubbing vegetable oil will remove the discoloring.
• Clean using a soft brush. Avoid contact with cutting blades on the bottom.
• Check lter sieve regularly for signs of damage. Do not use if damaged.
Juice Collector, Lid and all other parts:
• Wash in warm soapy water, rinse and dry. Do not use abrasive cleansers.