Filter
Top Products
32
SECTION 4
MAINTENANCE
6. To remove the inner plate, pull the plate out and then up.
Figure 4-11.
7. The outer nger plate is stainless and may be cleaned
by either soaking in a hot, strong detergent solution or
using a caustic cleaner. The conveyor belt can also be
cleaned in the same way.
Figure 4-12. Standard Lower Finger
Figure 4-13. Standard Upper Finger
C. Reassembly of Air Fingers
1. Air ngers are made up of one inner plate, one outer
plate and the nger housing manifold. Be sure to match
up the markings (T1, T2, T3, etc.) on all the parts of the
air ngers as you are reassembling.
Figure 4-14.
2. Reassemble the inner plate. Keep your ngers clear
so you won’t pinch them. The inner plate of a nger will
only go in one way because of its design.
3. Replace the outer plate by placing your hands at on
the top of the plate and pushing down. Keep your ngers
clear so you won’t pinch them.
Figure 4-15.