Filling the salt reservoir
If your water hardness level is greater
than 8 gr/gal (140 ppm), the salt
reservoir should be filled before the first
use and when the "Salt" indicator lights.
Only use water softener salt specially
formulated for dishwashers. Other salts
may contain insoluble additives which
can impair the water softener.
The proper salt can be purchased from
your Miele dealer or Miele’s Technical
Service Department.
,
Inadvertently filling the salt
reservoir with dishwashing
detergent will damage the water
softener.
To fill the salt reservoir:
^
Remove the lower basket
^
Unscrew and remove the salt
reservoir cap located on the floor of
the wash cabinet.
^
Place the provided funnel over the
salt reservoir.
The salt reservoir must be filled with
2 quarts (2 l) of water before adding
salt for the first time. Water does
not have to be added with
subsequent refills.
^
Carefully fill with salt. The salt
reservoir holds approx. 4.5 lbs (2 kg)
of salt. As it is filled, water will run
out.
^
Clean any excess salt from the
threads of the reservoir opening.
^
Screw the cap on firmly.
^
If the dishwasher will not be used
immediately, run the "Rinse & Hold"
program. This will remove any traces
of salt from inside the wash cabinet.
Before using for the first time
15