Filter
Top Products
^ Open the upper door, and pull it
downwards and off. Take care not to
lose washer a.
^ Using a screwdriver remove covers
b.
^ Unscrew upper hinge pin c using
the spanner supplied, and refit on the
opposite side.
^
Put covers b back on again from
behind and then push them firmly
into place.
^
Exchange cover h in the middle of
the appliance with hinge bracket e.
To do this:
Undo screws i, pull cover h and
hinge bracket e off to the side, turn
around and refit and screw into
position on the opposite side.
^
Pull bearing bush d downwards out
of hinge bracket e and refit it from
above into the hinge bracket.
^
Remove spacer g with a screwdriver
and refit it on the opposite side.
^
Remove plugs j from the door
bearing bushes in the doors and refit
on the opposite side.
^
Hang the upper door in hinge pin c
(remember to use washer a), then
close the door.
^
Push middle hinge pin f from below
through hinge bracket e into the
upper appliance door.
^
Check that the upper door is
correctly aligned. If necessary align it
using the long slots in hinge bracket
e.
^ Hang the lower door in hinge bracket
e then close the appliance door.
Changing the door hinging
42