Filter
Top Products
Anti-tip device
75
1
3
2
Attaching to the floor
1
3
2
Attaching to the wall
&
Anti-tip device
'
Screws
(
Locking nut
ĺ Secure the anti-tip device Ȧ to the
floor surface with suitable bearing
capacity, either to the floor or wall.
using four screws ȧ.
ĺ Screw the locking nut Ȩ to the bolt,
see the "Installation dimensions of
locking bolt" table.
Do not push the range into
position until all the utility
connections have been made.
The toe-kick cover is attached to the
base of the range by magnets.
21
&
Toe-kick cover
'
Locking clamp
ĺ Remove the toe-kick cover Ȧ from
the appliance.
ĺ Pull out the locking clamp ȧ.
The locking clamp extends through
the toe-kick plate of the range
housing. Its length is approximately
equal to the depth of the range.
A slot is located in the non-visible rear
section of the locking clamp. This slot
will engage with the bolt of the anti-tip
device when you slide the locking
latch in
to the range.