Filter
Top Products
The message "Insert water tank until it engages" appears
Possible fault Solution
No water is dispensed.
–
The water tank is not inserted properly.
Take it out and reinsert correctly.
–
The water tank was not filled correctly
during the descaling process. Fill the
water tank up to the correct mark.
–
If the message still appears contact
Technical Service.
The message "Check water inlet" appears
Possible fault Solution
The plumbed water intake is faulty.
–
Check for kinks in the water intake hose
and open the water supply all the way.
– Slide the water tank back in to the
appliance.
– If the fault is displayed again, call
Technical Service.
The gasket of the coffee dispenser connector is damaged and leaking.
Possible fault Solution
– The gasket is worn.
–
Check the door. Is the alignment
off from damage to the gasket?
– Change the gasket with a new one
(supplied).
–
Adjust the door hinges. See "Installation -
Adjusting the door hinges".
Too much crema has formed and is above the coffee dispensers.
Possible fault Solution
Some coffee types produce too
much crema when the coffee /
espresso temperature is set to the
maximum and the amount of
ground coffee is too much.
Lower the temperature and amount of
coffee.
Frequently asked questions
62