Filter
Top Products
Installation
Before installation make sure that there is no power supply
to the machine. This also applies should it ever need to be
taken out of its housing unit.
The machine must be built-in before it is operated.
^
Push it all the way into the niche until there is resistance.
Then check the height to make sure it is sitting centrally in
the unit and that it is level.
If this is not the case you can adjust the height of the 4 feet
underneath the machine using the large spanner.
The feet can be unscrewed by approx. 10 mm.
^
If the furniture unit walls are 19 mm thick you will need to
drill four holes in the sides for securing the machine. To
mark the position of these holes:
–
Align the machine in the niche, then slightly unscrew the
side hexagon screws to make an indent in the side walls.
Then screw them back in again.
–
Take the machine out of the niche and drill ø 4.5 mm holes,
2 mm deep, where you made the indentations.
Installation
82