Filter
Top Products
The message "Insert water tank until it engages" appears
Possible fault Solution
No water is dispensed.
–
The water tank is not inserted properly.
Take it out and reinsert correctly.
–
The water tank was not filled correctly
during the descaling process. Fill the
water tank up to the correct mark.
–
If the message still appears contact
Technical Service.
The message "Check water inlet" appears
Possible fault Solution
The plumbed water intake is faulty.
–
Check for kinks in the water intake hose
and open the water supply all the way.
– Slide the water tank back in to the
appliance.
– If the fault is displayed again, call
Technical Service.
The gasket of the coffee dispenser connector is damaged and leaking.
Possible fault Solution
– The gasket is worn.
–
Check the door. Is the alignment
off from damage to the gasket?
– Change the gasket with a new one
(supplied).
–
Adjust the door hinges. See "Installation -
Adjusting the door hinges".
Too much crema has formed and is above the coffee dispensers.
Possible fault Solution
Some coffee types produce too
much crema when the coffee /
espresso temperature is set to the
maximum and the amount of
ground coffee is too much.
Lower the temperature and amount of
coffee.
The grind control slide will not move.
Close the unit and prepare a coffee/espresso. The grind grade can now be
reset.
Frequently asked questions
61