Filter
Top Products
... the lighting suddenly switches
itself off.
If the machine has not been used for 15
minutes the lighting will switch itself off
automatically. (See "Settings:
customising your machine - Lighting:
Setting the switch-off time").
... the machine does not switch on
even although the "Switch on at"
setting for the timer has been
activated.
The system lock has been activated.
^ Deactivate it. (See "Settings:
customising your machine - Safety
(Activating the System lock)".
The machine was not used after being
switched on automatically 3 times in
succession.
^ Switch the machine on and make a
drink.
... you cannot read the display.
If the machine is installed too low down,
the display can be hard to see.
^
Try to improve this by adjusting the
display contrast or brightness (see
"Settings: customising your machine -
Setting the display").
... only a little or no coffee or
espresso is dispensed from the
central spout.
Is the central spout connector cap
positioned correctly? (See "Guide to the
machine" - "Interior view").
^
Lubricate the cap with the silicone
grease supplied.
... milk froth or milk is not flowing out
of the central spout.
The spout is clogged up.
^
Clean the central spout (taking
special care to clean the rubber
stoppers thoroughly) and the milk
pipework as described in "Cleaning
and care".
... the consistency of the milk froth in
unsatisfactory.
The air intake tube is blocked.
^ Clean the air intake tube (See
"Cleaning and care" - "Central
spout"). Any blockages can be
dislodged by kneading or "blowing
through" the tube.
Do not use a needle or similar
implement. This would damage the
components.
The air intake tube is defective.
^
Remove the air intake tube and
replace it with the spare part
supplied.
Problem solving guide
64