Filter
Top Products
Setting the rinse aid dosage
You can adjust the rinse aid dosage to
optimize the results.
The rinse aid dosage can be set at
levels between 0 and 6 ml. The factory
setting is 3 ml of rinse aid. This is just a
recommendation.
If the dishes are spotty:
^ Use a higher rinse aid setting.
If the dishes are cloudy or streaky:
^ Use a lower rinse aid setting.
^ Press the K button to turn the
dishwasher off.
^ Press and hold the Start/Stop button
and simultaneously turn the
dishwasher on using the K button.
Keep the Start/Stop button pressed
for at least four seconds until the
"Start/Stop" indicator light comes on.
If it does not come on, start over.
^ Press the Delay start button three
times.
The Delay start indicator light flashes 3
times at short intervals.
The time display shows the flashing
sequence p3.
The set value is shown in the time
display after the P.
^ Select the desired dosage with the
Start/Stop button.
Every touch of the button increases
the level.
The setting is saved immediately.
^ Press the K button to turn the
dishwasher off.
Before using for the first time
13