Filter
Top Products
^
Hang the fixing bracket into the slits
in the machine door outer panel.
^ Push the overhanging ends of the
templates under the facia panel.
^
Adjust the fixing bracket a:
The long holes in the machine outer
door must be aligned with the
matching markings on the template.
^
Mark the height of the top edge of
adjacent kitchen base unit doors on
the template b.
^
Take off the fixing bracket.
^
Lay the door front down with the rear
side facing upwards.
^ Lay the bracket on the rear side of
the door front and adjust so that:
– the marks on the template for the
upper edge of the adjacent base unit
doors match the top edge of the
door front.
– the fixing bracket must be the same
distance from the left and right hand
side edges of the door front.
^
Use strips of adhesive tape to hold
the bracket in this position.
Installing integrated "i" Dishwashers
15