Filter
Top Products
^
Bow the panel slightly, pull it out from
under the control panel and take it
off.
^ Shorten the decor frame strips, and
the filler card (if used) by dimension
X.
^ When using the decor panel
supplied: Draw a line to join the two
marks for measurement X. Shorten
the decor panel along this line.
,
To avoid the risk of scratching
the decor panel and decor frame
strips you can cover the cutting lines
with adhesive tape. Make sure that
you use a tool which is suitable for
cutting the material from which the
panel and decor frame strips are
made. If in doubt seek professional
advice. Sand down any rough
edges.
When the decor frame strips are
shortened, the hook on the lower edge
is cut off. This hook is only needed for
maximum length decor frame strips. It
is used for securing the strips to the
door outer panel.
^
Loosen the screws a in the door
outer panel, but do not unscrew
completely.
^ Push the lower edge of the adapter
plate b (corresponding to dimension
X) upwards far enough for its lower
edge to be in a line with the lower
edge of the adjacent kitchen unit
door front(s).
^ Tighten the screws a in the adapter
plate.
Installing built-under "U" model dishwashers
29