Filter
Top Products
Cleaning and care
Cleaning catalytic enamel using the
“Extra cleaning process”
Before carrying out the extra cleaning
process take out the rack and side pa-
nels, and remove any soiling from the
“Clean-Enamel” areas.
To operate the extra cleaning process:
Turn the oven function selector to
“Fan Heat D”.
Turn the temperature selector to the
highest setting.
Let the oven operate for about one
hour. The length of time will depend on
the degree of soiling. It is a good idea
to set the finish time for the process
using the timer. This way you will not
forget to switch the oven off at the end.
Wipe over all visible surfaces which are
not protected by catalytic liners, espe-
cially the oven floor.
Every time the oven is used at high
temperatures any remaining soiling
will gradually disappear.
Should the catalytic coating on the
back panel or any other catalytic pa-
nels fitted become ineffective
through improper use or heavy soil-
ing, for example, a replacement can
be obtained from your Miele dealer
or Miele Spare Parts dept.
44